DMT系统中一种易于实现的时域均衡器

总结了DMT系统中时域均衡器(TEQ)的主要设计方法，指出最大缩短信噪比(MSSNR)TEQ的最优设计方法很难实时实现。提出了一种MSSNR TEQ的次优设计方法，它首先估计出目标抽样窗的最优延迟，然后用分步求解法求出TEQ的抽头系数。和最优方法相比，次优方法的计算量大幅度减少，可实时实现，而其缩短信噪比的损失很小。仿真实验验证了次优方法的有效性。     

纺织工业厂房设计类型浅探

总结了目前几种常见类型纺织厂房的特点，进行了技术经济指标对比，建议性地指出目前纺织工业厂房设计的方向。     

粗粒土渗透变形机制浅析

对砂卵砾石的渗透变形的形成条件进行了简要分析，在此基础上对渗透变形的形式进行了简要评价，并提出了渗透变形临界坡降的计算方法。     

Analysis of 24,444 surgical specimens accessioned over 55 years in an ophthalmic pathology laboratory

PURPOSE: To summarize the pathologic diagnoses of a large number of surgically-obtained specimens over an extended time period in a single ophthalmic pathology laboratory. METHODS: We analyzed the records of 24,444 surgically obtained specimens accessioned in the L.F. Montgomery Ophthalmic Pathology Laboratory, Emory University, Atlanta, GA between May 1941 and December 1995. Age, sex, topography, clinical procedure, and histologic diagnosis were entered into a database using the modified SNOMED coding system. The diagnosis of the surgically enucleated eyes were analyzed with respect to years of enucleation. RESULTS: The most common topographic area associated with a histologic diagnosis was the cornea (39.3%), followed by lens (16.0%), vitreous (12.0%), uvea (9.8%), eyelids (8.0%), conjunctiva (7.7%), retina (7.7%), and orbit (2.1%). The relative proportion of vitreous specimens has continuously increased and became the most common surgical specimen in 1995. The most common underlying disease of surgically enucleated eyes is trauma (40.9%), followed by ocular neoplasia (24.2%), 'surgical' diseases of the cornea, lens and retina including glaucoma (17.3%), vascular diseases (6.7%), and inflammatory conditions (6.7%). The relative frequency of trauma and ocular inflammation as a cause of enucleation decreased significantly (p < 0.05) over the time of the study period while the relative proportion of ocular neoplastic processes increased (p < 0.0001). CONCLUSIONS: The availability of new surgical techniques has caused a change in the relative frequencies of different ocular specimens submitted for histologic examination.     

Grain Boundary Sliding in Fatigue of Pure Aluminum

The distributions of plastic strain near grain boundaries induced by fatigue loading were investigatedby the fiducial grid method in pure aluminum specimens, and the resulted grain boundary sliding(GBS) was systematically analysed. The results show that the strain field near a grain boundary isnonuniform. GBS is restricted by the junction of grain boundaries and causes discontinuities of bothdisplacement and strain. A peak value of shear strain was created in short-range area across the grainboundary. GBS plays an important role in cyclic softening and secondary hardening. The control fac-tor of GBS is the relative orientation between two grains and the macro orientation of the grainboundary rather than the ∑ value of the boundary.     

TK406H侧钻短半径水平井钻井工艺技术

TK40 6H侧钻短半径水平井是西北石油局在塔河油田利用已钻无产能直井井眼侧钻钻水平井而布署的第一批短半径水平井 ,也是国内目前已钻的最深的短半径水平井 ,设计侧钻造斜井深在 5 30 0m以下 ,施工难度大 ,该批短半径水平井的钻成并获得良好的产能 ,使国内水平井钻井技术迈上了新的台阶。本文主要从该油田短半径水平井钻井的技术难点入手 ,对TK40 6H侧钻短半径水平井的设计和施工进行了分析和阐述 ,并通过主要工艺技术分析 ,阐明了技术实施的着眼点和配套的技术措施     

俄罗斯陶瓷及其金属化技术的研究

采用X射线荧光、X射线衍射、金相显微镜和扫描电镜等分析方法 ,通过对微波管陶瓷材料的理化分析 ,对俄罗斯陶瓷及其金属化技术进行了研究 ,并对化学成分和显微结构对性能的影响作了初步的讨论。     

无保护间隔的OFDM信道自适应均衡的一种新算法

近年来作为一种特殊的多载波调制方式——正交频分复用(OFDM)已得到越来越多的人的关注.对于传统的OFDM系统来说,如果循环前缀的长度大于信道的时延扩散值,则可以通过简单的频域均衡来解调OFDM信号.可是循环前缀的使用却降低了系统的传输效率,如果能压缩甚至去掉循环前缀,而保持系统性能不变,则是很有意义的,为此本文给出了一种新的均衡结构,利用循环迭代手段以减少甚至去掉循环前缀,最后通过计算机模拟,证实了这种结构的有效性.     

分析矩形光波导损耗的简易方法

利用有效折射率和修正的有效折射率方法对矩形光波导的损耗作了简单有效的分析，并且计算出了纵向传播系数和衰减系数的大小。     

Si1-xGex/Si应变材料的生长及热稳定性研究

利用分子束外延（MBE）技术生长了Ge组份为0.1-0.46的Si1-xGex外延层。X射线衍射线测试表明，SiGe/Si异质结材料具有良好的结晶质量和陡峭界面，其它参数与可准确控制。通过X射线双晶衍射摆曲线方法，研究了经700℃、800℃和900℃退火后应变SiGe/Si异质结材料的热稳定性。结果表明，随着退火温度的提高，应变层垂直应变逐渐减小，并发生了应变弛豫，导致晶体质量退化；且Ge组分越小，Si1-xGex应变结构的热稳定性越好；室温下长时间存放的应变材料性能稳定。